한국요꼬가와전기
Leading Edge Controller (with MECHATROLINK-Ⅱ Interface)
Spec
- M-Ⅱ
- M-Ⅲ
- M-4
MDevice
컨트롤러
- Category
- Category1（）
Features
FA-M3V is the result of a quest for high performance and advances functionality. FA-M3R features minimum scan time of 100μs and is faster than microcomputer boards.
F3NC96-0N Positioning Module supports MECHATROLINK-Ⅱ, an open field network standard designed for high-speed motion control, and is the No.1 choice for configuring a system involving many controlled axes.
F3NC96-0N Positioning Module supports MECHATROLINK-Ⅱ, an open field network standard designed for high-speed motion control, and is the No.1 choice for configuring a system involving many controlled axes.
- Occupying a single slot of the base module, the module can control up to 15 axes (motors), and can be easily connected to motors using connectors, requiring minimal wiring time and cost.
- A high baud rate of 10 Mbps supports a short cycle time of 1 ms per set of 8 axes, which means quicker response and better synchronization with peripheral devices.
- Command transmission enables maximum utilization of motor performance (high speed and resolution) to achieve fast and accurate positioning control.
(with MECHATROLINK-Ⅱ Interface)
Specifications
| Item | Specifications | |
|---|---|---|
| Interface | MECHATROLINK-Ⅱ compliant | |
| Transmission rate | 10Mbps | |
| Transmission byte | 32 bytes | |
| Cycle time/ no. of stations | 1.0 ms for up to 8 axes, 2.0 ms for up to 15 axes (user selectable) | |
| Network Topology | Bus (multi-drop) | |
| Communication method | Master/slave synchronous | |
| Transmission media | 2-wire shielded twisted pair cable (proprietary cable) | |
| Max. transmission distance | 50 m (total length) | |
| Min. distance between stations | 0.5m | |
| Positioning functions | Position reference | −2,147,483,648 to 2,147,483,647 (reference unit) |
| Functions | • Linear interpolation movement (starting and stopping multiple axes simultaneously) • Independent axis movement using MECHATROLINK-Ⅱ commands (dependant on connected external equipment and supported MECHATROLINK-Ⅱ commands) |
|
| Others | • Reading of statuses (target position, current position, etc.) of external equipment • Reading and writing of parameters of external equipment |
|
MECHATROLINK specifications
| M-Ⅰ | M-Ⅱ | |||
|---|---|---|---|---|
| 17-byte | 17-byte | 32-byte | ||
| Command | Servo | - | - | × |
| Stepping Motor Drivers | - | - | × | |
| Intelligent I/O | - | - | - | |
| Simple I/O | - | - | - | |
| Inverter | - | - | - | |
| Transmission cycle | 1ms, 2ms | |||
Contact Information
Yokogawa Electric Corporation
| 2-9-32, Nakacho, Musashino-shi, Tokyo 180-8750, Japan | TEL : +81-422-52-5616 | FAX : +81-422-52-9802 |
E-mail : plc_message@csv.yokogawa.co.jp
URL : http://www.yokogawa.com
